What do Directional Drills need to pay attention to in winter?

How to maintain the directional drilling rig in winter? How can we ensure the normal operation of directional drilling rig? What should we do so that the directional drilling rig can work normally in the cold winter? We should do the following:

(1) Preheat the directional drill in advance before using it. In general, the directional drilling rig is very difficult to start under very low temperature, and it may also happen that when the normal directional drilling rig is working, the directional drilling rig suddenly fails to work and suddenly stalls. When this happens again, the first thing we should do is to turn on the directional drilling rig in advance for preheating. Generally, the directional drilling rig needs to be preheated for half a minute. When turning on the directional drilling rig, we must control the opening time every time. Generally, it takes 5 or 6 seconds each time to turn on the directional drilling rig for 3-4 times. If the directional drilling rig has not been turned on, we need to wait at this time, Wait a few minutes and operate again to protect the directional drilling rig.

(2) The engine of the directional drilling rig and the preheating of the hydraulic system of the directional drilling rig. When the temperature is relatively low, do not suddenly open the directional drilling rig in a special hurry. If you suddenly open the directional drilling rig at this time, it will cause serious damage to the directional drilling rig. Generally, we should warm up the directional drilling rig a few minutes in advance.

(3) Protect the parts of the horizontal directional drilling rig that store electricity when the temperature is relatively low. When the temperature slowly decreases, the capacity of the parts of the storage point of the directional drilling machine will be reduced. In this case, we need to protect the parts of the storage point of the horizontal directional drilling machine with cotton cloth or other items. We can also disassemble the parts of the horizontal directional drilling machine that store electricity, store them in a relatively high temperature place, and install them when the horizontal directional drilling machine is used the next day.